
1. The device has a built-in rechargeable battery that needs to be fully charger when the device is new.
2. Make sure to insert a MicroSD card before using the device.
3. Press and hold ON/OF to turn on the device. The yellow LED will turn on , which means the device is in STANDBY mode.
4. Press and hold REC to start recording video. The yellow LED will blink fast three times, then turn off. This means that during video recording, the LED is not lit, which makes it less likely to be spotted.
5. Press REC to pause video recording and save the recording to that point. The LED will turn on. The device is now is STANDBY mode. In STANDBY mode, press REC to take a still image. To continue recording press and hold REC.
6. To record a still image: Turn on the devise by pressing and holding ON/OF to enter STANDBY mode. The LED will turn on. Press REC to record a single still image. The LED will flash. Press REC for another image.
7. To set the data/time of the devise, which is used to timestamp media recordings, create a text file in the root of the MicroSD card with a file name of TAG. TXT. Open the file and add the following three lines: (date) 2009/10/22. 03:45:00 Replace the data and time above with the values you want. Save the file. Turn the devise off, then back on to reset the clock based on the text file.
8. To turn off the devise, press and hold ON/OF until the LED goes out.
9. The device powers off by itself after a period of inactivity.
10. It's not necessary to power on the device to access recorded media via the USB cable.
11. If the device stops functioning, use the reset button to reset the device. The reset button is recessed inside the small hole between the MicroSD card and the USB potr.
No comments:
Post a Comment